Falcon II Outdoor series printers – Maintenance Manual
114
AP-74065, Rev. 1.0, 21/11/03
4.7.5. Replacing the CR_ENC assembly
Notes :
¾
Remove following cover before replacing the CR_ENC assembly.
Side cover L: refer to "Removing side cover L"
Step 1 :
Follow step 1 in "Replacing the flushing box assembly" to slide the CR cursor to the left.
Step 2 :
Remove the CR_ENC assembly connector from the CR board assembly.
Step 3 :
Remove the T fence from the T fence spring, and then from the CR_ENC assembly.
Step 4 :
Remove the 2 screws fixing the CR_ENC assembly.
1 = CR_ENC assembly
2 = Screws (M2x12) fixing the CR_ENC assembly
Step 5 :
Replace the CR_ENC assembly.
Step 6 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
¾
When removing the T fence from the CR_ENC assembly, be careful not to damage
the T fence.
