Falcon II Outdoor series printers – Maintenance Manual
284
AP-74065, Rev. 1.0, 21/11/03
(1) Check if the
message is still
displayed after
turning the power
off and then back
on again.
• When a message
is displayed : refer
to step (2)
(2) The number of
times the print
head was used
reached the
maximum
allowable times.
• Replace the print
head assembly.
• Initialize the head
unit.
→
Replacing the
print head
assembly and
head tape power
cable.
→
Counter
initialization
menu.
10 (Warning
Head Life)
The service life of
the print head will
soon be reached.
(3) If initialization
does not take
effect when the
head unit is
initialized, the
Mainboard
assembly may be
damaged.
• Replace the
Mainboard
assembly.
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly
(1) Check the
connections of
connectors.
• Redo the
connections of the
following
connectors.
• Mainboard : J102
• power source
board (small)
assembly : CN51 –
CN52
(2) The
HDD_MOTHER
board assembly
may be damaged.
• Replace the ink
tube.
• Initializing CR
motor history.
(3) Hard disk may
be damaged.
• Replace the hard
disks.
11 Hard
disk
status conect
error
There is a problem
in the hard disk
connections.
(4) The Mainboard
assembly may be
damaged.
• Replace the
Mainboard
assembly.
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→
Replacing the
power source
board assembly.
(1) The
PCI_LINUX board
assembly may be
damaged.
• Replace the
PCI_LINUX board
assembly.
12 Network
initialize error
There is a problem
in the network
board.
(2) The Mainboard
assembly may be
damaged.
• Replace the
Mainboard
assembly.
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
13
Waste ink tank
sts. No
The waste tank is
not installed.
(1) Check if the
waste bottle has
been installed.
• Install the waste
bottle correctly.
-
