Falcon II Outdoor series printers – Maintenance Manual
259
AP-74065, Rev. 1.0, 21/11/03
7.15.2. Replacing the pump assembly (Rockhopper 2 heater)
(1) For 50 or 64 inch spec
Notes :
¾
When the pump assembly has been installed to the main body, "pump 1" is the
pump on the left and "pump 2" the one on the right, viewed from the front.
1 = Pump 1
2 = Pump 2
Step 1 :
Remove the carriage cover according to "Removing the carriage cover".
Step 2 :
Remove the maintenance cover according to "Removing the maintenance cover".
Step 3 :
Following the instructions in "Self-Diagnosis Functions", start the equipment up in the self-diagnosis mode and
release the head lock.
Step 4 :
Following the instructions in "Replacing the Maintenance Assembly", disconnect the tubes connecting side plate
T and the cap to the pump assembly.
Step 5 :
Remove the tubes and connectors, etc., from the locking wire saddle of side plate F.
Step 6 :
Remove side plate F.
