Falcon II Outdoor series printers – Maintenance Manual
239
AP-74065, Rev. 1.0, 21/11/03
7.7. HEAD PRECISION ADJUSTMENT
This section explains the procedure for adjusting the head angle.
When replacing the head assembly, use the following procedure to adjust the head angle and head forward/rear position.
Notes :
¾
When the 6-colour mode has been activated, heads in which a cleaning cartridge
has been inserted will not spray. Consequently, these heads cannot be adjusted.
Perform adjustments in all modes except for 6-colour mode.
7.7.1. Head angle adjustment
Step 1 :
Start the self-diagnostic function.
Notes :
¾
Refer to “Self-Diagnosis Function”
Step 2 :
Select "Adj:HeadSlant".
Step 3 :
Print "Slant" pattern.
Notes :
Printing pattern is printed with the head sequence shown below.
¾
50, 64 inch model: 1A, 1B, 2A, 2B, 3A, 3B, 4A, 4B
¾
87 inch model: 3A, 3B, 1A, 1B, 2A, 2B, 4A, 4B, 5A, 5B, 6A, 6B, 7A, 7B, 8A, 8B
Step 4 :
Loosen the screw fixing the head stationary plate.
1 = Screw (M2.5x5) fixing the head stationary plate
2 = Angle adjustment screw
