Falcon II Outdoor series printers – Maintenance Manual
19
AP-74065, Rev. 1.0, 21/11/03
7
Media cut groove
Only onto the Falcon II Outdoor 4H printer !
Used to cut the media straight when it is cut manually.
8
Carriage cover
Only onto the Falcon II Outdoor printer !
This is a cover to protect the user from the internal components of the
unit. This is opened during following operation :
¾
When cleaning the cleaning wiper
9
Foot switch
This switch is used to raise and lower the pressure rollers.
10
Paper Guide
Support the media during printing
In the Falcon II Outdoor it houses post-heater (dryer).
In the Falcon II Outdoor 4H it houses the fixer, post-fixer and dryer.
2.3.2
.
Back
No.
Name
Function
1
AC inlet
This is the inlet interface to which the power plug is connected.
2
Interface connector
This is the connector to which the interface cable is connected.
3
Foot switch connector
This is the connector to which the foot switch cable is attached.
4
Insertion slot
This is the slot for inserting media when loading it.
5
Interface slot 1
The network interface board attaches here.
6 Interface
slot
2
7 Interface
slot
3
This is not used for this printer.
Close it with the cover.
8
Hard disk slot
The hard disk attaches here. When not using a hard disk, keep the
cover closed.
9
Nameplate rating
The type, name, serial number, rating and other details of the printer are
labelled here.
10
Rear Heater
Supports the media during printing and houses the pre-heaters.
