Falcon II Outdoor series printers – Maintenance Manual
63
AP-74065, Rev. 1.0, 21/11/03
Step 8 :
Remove the screws of the plot platform.
1 = screws plot platform
Step 9 :
Pull upwards the plot platform calibre and so remove the plot platform with fixer.
Step 10 :
Remove the fixer.
Step 11 :
Degrease the plot platform.
Notes :
¾
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Step 12 :
Stick the two fixer strips onto the plot platform.
Notes :
¾
Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
Step 13 :
Stick the isolation tape onto the heater strips.
