Mitsubishi Electric City Multi CMH-WM250V-A, Service Handbook

Page: 352 / 436

[8-13 Parts Replacement Instructions ]
BS_08_E chapter 8 -
97
8 Troub
le
sho
oting Bas
ed on Ob
ser
ved
Sy
mp
toms
[Drain pan mounting procedure]
*Reuse the drain pan mounting screws that were removed from the replaced drain pan. (M5 x 16 mm with a nylon washer)
(1) Screw down the drain pan with two screws. (See Figure 7.)
(2) Hold the check joints to the drain pan with two rod holders. (See Figure 8.)
(3) Make sure that the silicon tube is properly placed on the defrost pipe, and then place the drain pan cover.
Place the drain pan cover along the defrost pipe, and fit it to the drain pan. (See Figures 9 and 10.)
(4) Thread a cable tie through the rectangle hole on the screwed-down drain cover, and hold the silicon tube and the defrost
pipe together in place. (See Figure 11.)
(5) Screw down the front panel with eight screws. (See Figure 12.)
Drain pan
Check joint
Rod holders
Silicon tube
Defrost pipe
Defrost pipe
Cable tie
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Make sure that the tab on the drain pan is
properly placed in the groove, and screw down
the drain pan with two screws (front and back).
Make sure that the silicon tube is properly placed on
the defrost pipe, and then place the drain pan cover.
Align the drain pan
and the cover.
Front panel
0000004986.BOOK 97 ページ ２０１９年５月９日 木曜日 午後６時２２分