Mitsubishi Electric City Multi CMH-WM250V-A, Service Handbook

Page: 360 / 436

[8-13 Parts Replacement Instructions ]
BS_08_E chapter 8 -
105
8 Troub
le
sho
oting Bas
ed on Ob
ser
ved
Sy
mp
toms
(18) Before removing the front heat exchanger, protect the surrounding electrical components and the pipe cover with a
recommended cloth soaked in water, and then remove the braze from six areas. (See Figure 13.)
To remove the rear heat exchanger, remove the braze from four areas. (See Figure 14.)
(19) To remove the front heat exchanger, loosen the screws on the right side of the right rear pillar. (4 screws on a standard
model or 3 screws on a high-efficiency model) (See Figure 15.)
To remove the rear heat exchanger, loosen the screws on the back of the right rear pillar. (3 screws on a standard model
or 2 screws on a high-efficiency model) (See Figure 16.)
Remove the screw holding the pillar to the rear heat exchanger support. (See Figure 16.)
Remove the braze from the
areas encircled in the figure. Remove the braze from the
areas encircled in the figure.
Loosen the screws.
Unscrew the screws.
Connection of the pillar to the
front heat exchanger (4 screws on
a standard model or 3 screws on
a high-efficiency model)
Connection of the pillar to the rear
heat exchanger (3 screws on a
standard model or 2 screws on a
high-efficiency model)
Loosen the screws.
Removing the front heat exchanger
(Figure 13)
Removing the rear heat exchanger
(Figure 14)
Removing the front heat exchanger
(Figure 15)
Removing the rear heat exchanger
(Figure 16)
0000004986.BOOK 105 ページ ２０１９年５月９日 木曜日 午後６時２２分