Form No.
S3412-1112
Supersedes
S3412-712
Page
1 of 12
Aluminum Finned Copper Coils:
Grooved tubing and enhanced louvered
fin for maximum heat transfer and energy
efficiency.
Twin Blowers:
Move air quietly. All models feature
multispeed ECM blower motors providing
airflow adjustment for high and low static
operation. Motor overload protection is
standard on all models.
ECM Indoor Blower Motor:
Features a variable speed motor providing
super-high efficiency, low sound levels
and soft-start capabilities. The motor is
self-adjusting to provide the proper airflow
rate for the staged capacity, and for
higher static pressure in ducted
installations without user adjustment or
wiring changes.
Air Conditioner Compressor:
Copeland scroll compressors are
designed for increased efficiency, quieter
operation and improved reliability for
longer life. Eliminates need for crankcase
heater.
R-410A Refrigerant:
Designed with R-410A (HFC) non-ozone
depleting refrigerant in compliance with
the Montreal protocol and 2010 EPA
requirements.
Phase Rotation Monitor:
Standard on all 3 phase scroll
compressors. Protects against reverse
rotation if power supply is not properly
connected.
Galvanized 20 Gauge Zinc Coated Steel
Cabinet:
Cleaned, rinsed, sealed and dried before
the polyurethane primer is applied. The
cabinet is handsomely finished with a
baked on textured enamel, which allows it
to withstand 1000 hours of salt spray tests
per ASTM B117-03.
Foil Faced Insulation:
Standard on all units.
The Bard Wall-Mount Air Conditioner is a self contained energy efficient system, which
is designed to offer maximum indoor comfort at a minimal cost without using valuable
indoor floor space or outside ground space. This unit is the ideal product for versatile
applications such as: new construction, modular offices, school modernization,
telecommunication structures, portable structures or correctional facilities. Factory or
field installed accessories are available to meet specific job requirements.
THE WALL-MOUNT™ “Quiet Climate” A/C – 10.0 EER
G
REEN
R
EFRIGERANT
R-410A
Models W38A1, W49A1, W61A1
3 to 5 Ton (35,600 to 57,500 Btuh)
Right Side Control Panel
60Hz
Engineered Features
Full Length Mounting Brackets:
Built into cabinet for improved
appearance and easy installation.
NOTE: Bottom mounting bracket
included to assist in installation.
Electrical Components:
Are easily accessible for routine
inspection and maintenance through a
right side, service panel opening.
Features a lockable, hinged access cover
to the circuit breaker or toggle disconnect
switch.
Electric Heat Strips:
Features an automatic limit and thermal
cut-off safety control. Heater packages
can be factory or field installed for all 1
½
through 5 ton models.
Filter Service Door:
Separate service door provides easy
access for filter change.
One Inch, Disposable Air Filters:
Are standard equipment. Optional one
inch washable filters available and filter
racks permit the addition of 2" pleated
filter. Factory or field installed.
Condenser Fan and Motor
Shroud Assembly:
Slides out for easy access.
Barometric Fresh Air Damper:
Standard on all units. Allows up to 25%
outside fresh air. Optional ventilation
packages available.
Built-in Circuit Breakers:
Standard on all electric heat versions of
single (230/208 volt) and three phase
(230/208 volt) equipment. Rotary
disconnects are standard on all electric
heat versions of three phase (460 volt)
equipment.
PTCR Start Assist:
Standard on 1-phase models.
Slope Top:
Standard feature for water run-off.
Top Rain Flashing:
Standard feature on all models.
Liquid Line Filter Drier:
Standard on all units. Protects system
against moisture.
Compressor Control Module:
Standard on all units. Built-in off-delay
timer adjustable from 30 seconds to 5
minutes. 2-minute on-delay if power
interrupt. 120-second bypass for low
pressure control, and both soft and
manual lockouts for high and low pressure
controls. Alarm output for alarm relay.
High & Low Pressure Switches are
Auto-Reset:
Standard on all units. Built-in lockout
circuit resets from the room thermostat.
Provides commercial quality protection to
the compressor.
•
Complies with efficiency requirements of ANSI/ASHRAE/IESNA 90.1-2010.
•
Certified to ANSI/ARI Standard 390-2003 for SPVU (Single Package Vertical Units).
•
Intertek ETL Listed to Standard for Safety Heating and Cooling Equipment ANSI/UL
1995/CSA 22.2 No. 236-05, Fourth Edition.
•
Commercial Product - Not intended for Residential application.
