![background image](http://html1.mh-extra.com/html/mircom/flex-net-bbx-1024ds/flex-net-bbx-1024ds_application-manual_1805815204.webp)
204
Using the Configurator
19.51.6 Correlating selector switches to remote telephones
The following constraints apply to correlations between telephones and switches.
•
Each dual LED/Switch combination on a Selector can control and annunciate only one
telephone (conventional circuit or addressable module).
•
If a switch on one CPU (Annunciator) is already controlling a telephone, then no other
switch on that same CPU can be associated with the same telephone. However, any
given telephone module can be controlled from a similar LED/Switch combination on
another CPU.
Typically, a bank of selectors on one Annunciator mirrors those on another. However, this is
not required. For example, the Selector Switches at the Main Panel could control all the phone
modules on a job, while each remote Annunciator controls only a sub-set.
Correlate a selector switch to a telephone
1. Select the addressable loop or audio controller phone list view containing the telephone.
2. Click
Insert
in the menu bar, then click
Add Correlations
.
3. Click a maximum of one switch from each CPU that you want to correlate with this
telephone.
4. Click
Add
.
If you had previously correlated one or more switches to this telephone module, then you will
not see any available switches from the same CPU as those existing correlations.
Correlate a phone module to a switch
1. Select the Selector Switch.
2. Click
Insert
in the menu bar, then click
Add Correlations
.
3. Click
only
one
Phone Module
. A switch cannot control more than one telephone.
4. Click
Add
.
If the phone you added was already correlated to another switch on the same CPU, you will
receive a message "A select switch already exists for control circuit number nnn. A circuit can
only be assigned to one Telephone Switch per CPU".
If you selected more than one Phone to add, or if you press add again, then you will receive
the error message “Cannot correlate a Phone Select switch to more than one phone module”.
19.51.7 A fire phone device cannot be copied if it is already correlated to a
selector switch
A fire phone device cannot be copied if it is already correlated to a selector switch. If you
attempt to copy such a device (or a loop that contains one) an error message appears. If you
need to copy phones, use
Paste Special
and unselect
Copy display correlations
.