158
Using the Configurator
Dialer
Configure the dialer with the Configurator
1. Remove the UIMA4 cable from the FX-2000N panel and plug it directly to the dialer.
2. Short the jumper marked
JW2
on the dialer.
Auto test
Use this function to set the time for the automatic test.
When this test is performed, the test report is sent to the
monitoring station. This test must be performed at least
once a day.
The Auto test time can be
configured to:
12:00 a.m. to 5:59 a.m.: test every 24 hours
6:00 a.m. to 11:59 a.m.: test every 6 hours
12:00 p.m. to 23:59 p.m.: test every 12 hours
If
Line 2 cellular test
is unselected, then the test
alternates between Line 1 and Line 2. See section
19.11.1 on page 159 for more information.
To minimize receiver congestion, do not use the
following test times: 12:00 a.m., 01:55 a.m., 02:00 a.m.
and 03:00 a.m.
Line retries
Select the number of retries that you want the dialer to
make.
Rings
You can program the dialer remotely over a phone line.
Select the number of rings before the dialer answers
when you call it.
Warning
: If this is set to zero the next dial-in session will
not connect.
Mode
Select
DACT
or
UDACT
. The UDACT mode includes
information about the zone when the dialer calls the
monitoring station.
Enable
Unselect this check box if you want to set the dialer to the
disabled state when you send the job to the panel. The
dialer is enabled by default.
Aux disconnect
The dialer blocks the alarm and supervisory events from
being reported after the auxiliary disconnect button is
pressed.
Advanced Addressing
Enables the use of a conversion formula to transmit Node,
Loop and Device Address information in Contact ID
protocol. The receiver must also have conversion
software to properly display the additional information.
Advanced CID Report
If
Advanced Addressing
is selected, click this button and
select a location to save a report of all the points on the
system. This report can be used to inform the Central
Station of the Node, Loop, Absolute Address, CID String,
and Tag for each point.
The file name is
JobName_JN-JV.csv
where JN is the
job number and JV is the job version.