Mindray BeneHeart D3, Operator'S Manual

Page: 48 / 186

5-8
5.8 Pausing Alarm Sounds
You can press the [ Audio Pause ] softkey to pause alarm tones. In this case, the symbol will be displayed in the
sound symbol area indicating all system sounds are silenced temporarily. In the audio paused status, all alarm indicators
except audible alarm tones works properly. If alarms are switched off or paused, the [ Audio Pause ] soft key is not
shown.
The audio paused status is exited when,
„
The [ Audio On ] soft key is pressed.
„
Other alarms occur. Or
„
The hardkey is pressed to permanently or temporarily switch off the alarms.
5.9 Switching Off Alarm Sounds
In the event that [ Audio Off ] is enabled, to switch off the alarm tone, set [ Alm Volume ] to 0 while operating in Monitor
mode, Manual Defib mode or Pacer mode. In the audio off status, appears in the sound symbol area. In this case,
the alarm status is the same with that when alarm tones are paused.
The audio off status is exited when:
„
The hardkey is pressed. In this case, the equipment enters the alarm paused status and the alarm volume is
reset to the default level. The symbol is displayed in the sound symbol area.
„
The [ Audio Pause ] soft key is pressed. In this case, the equipment enters the audio paused status and the alarm
volume is reset to the default level. The symbol is displayed in the sound symbol area.
„
Operating mode is switched. Then the equipment enters the default alarm status of corresponding operating mode.
Or
„
Alarm volume is changed to a value between 1 and 10.
5.10 Reminder Tones
When alarms or alarm sounds are turned off, the equipment can give a reminder tone of a single beep every 60 seconds.
The reminder tone is switched off by default. You can switch it on by selecting [ Alarm Setup ]
→
[ Reminder Tone ]
through the Configuration Management Main menu. You can also change reminder volume. The default reminder
volume is [ Med ].