Mindray BeneHeart D3, Operator'S Manual

Page: 140 / 186

22-12
22.3.9.6 Formatting Storage Card
You can format the storage card if data in the card is useless, or if the card has a failure. To format the storage card, select
[ Format Data Card ] [
→
Format ] through the Installation Mode Main menu. Then a dialog box pops up as shown below:
If storage card is formatted successfully, a prompt “Formatting is completed!” appears. If there is a failure, the system
stops formatting and present a prompt “Formatting fails!”. Contact the service personnel if formatting fails for 3 times”.
22.3.10 NIBP Overpressure Protection Test
We recommend this test to be carried out once every year. The guidelines for completing this test are as follows:
1. Open the equipment’s enclosure, remove the multi-parameter monitoring module (M51A module), disconnect the
air tube from the pressure measuring sensor (component U26 on the digital board), and then block the tube.
2. Connect the NIBP cuff.
3. Press the NIBP hard key on the equipment’s front panel to start NIBP measurement. When the pressure exceeds the
hardware overpressure protection value (300 to 330mmHg), verify that the valve opens to release the air and the
alarm “NIBP Cuff Overpress” is shown on the screen.
The test is passed if you hear the valve discharge the gas properly and the “NIBP Cuff Overpress” alarm is given.
Otherwise, contact the service personnel.
22.3.11 Electrical Safety Tests
For details about Electrical Safety Tests, refer to Appendix E Electrical Safety Inspection .