Mindray BeneHeart D3, Operator'S Manual

Page: 100 / 186

13-4
13.6 Understanding the NIBP Numerics
The NIBP display shows numerics only as below. Your display may be configured to look slightly different.
1. Measurement mode
2. Pressure unit: mmHg or kPa
3. NIBP alarm high limit
4. NIBP alarm low limit
5. Time of last measurement
6. Systolic pressure
7. Diastolic pressure
8. Mean pressure at the completion of measurement, or cuff pressure during the measurement
13.7 Setting Initial Cuff Inflation Pressure
You can set the initial cuff inflation pressure manually. In the [ NIBP Setup ] menu, select [ Initial Pressure ] and then
select the appropriate setting. The cuff is inflated accordingly at the next NIBP measurement.
The table below list the setting range of initial cuff inflation pressure:
Patient category Range (mmHg) Default (mmHg) Accuracy (mmHg)
Adult 80 to 280 160
Pediatric 80 to 210 140
Neonate 60 to 140 90
10
NOTE
z
Setting initial cuff inflation pressure is disabled during NIBP measurement.
z
The initial cuff inflation pressure is restored to the default setting if NIBP module has been reset or patient
category has been changed.
13.8 Setting Pressure Unit
To set pressure unit, access configuration management. In the Configuration-Main menu, select [ NIBP Setup ]
→
[ Press.
Unit ] and toggle between [ mmHg ] and [ kPa ].
You can change NIBP unit only through configuration management.
2 1
3
4
5
7
6
8