Mindray BeneHeart D3, Operator'S Manual

Page: 44 / 186

5-4
5.4 Alarm Tone Configuration
5.4.1 Changing the Alarm Volume
1. Press the Main Menu button on the front panel, and then select [ Alarm Setup >> ] [
→
Alm Volume >> ].
2. Set [ Alm Volume ] to an appropriate level:
‹
If [ Audio Off ] is enabled, alarm volume can be set to a value between 0 and 10, in which 0 means audio off and
10 the maximum volume level.
‹
If [ Audio Off ] is disabled, alarm volume can be set to a value between 1 and 10, in which 1 is the minimum
volume level and 10 the maximum.
To disable or enable [ Audio Off ], access configuration management.
The setting of alarm volume will not be saved when the system is power off.
You can also set alarm volume in configuration mode. In this case, the setting will be saved.
NOTE
z
You cannot adjust alarm volume when an alarm is switched off.
5.4.2 Setting the Interval between Alarm Sounds
1. Press the Main Menu button on the front panel, and then select [ Others >> ] [
→
Configuration >> ] enter the
→
required password.
2. Select [ Alarm Setup >> ] to enter the [ Alarm Setup ] menu.
3. Respectively set [ High Alarm Interval (s) ], [ Med Alarm Interval (s) ] and [ Low Alarm Interval (s) ].
WARNING
z
Do not rely exclusively on audible alarm system. Setting alarm volume to a low level may result in a hazard
to the patient. Always keep the patient under close surveillance.
5.5 Understanding the Alarm Setup Menu
Press the Main Menu button on the front panel, and then select [ Alarm Setup >> ] to enter the Alarm Setup menu.