Mindray BeneHeart D3, Operator'S Manual

Page: 37 / 186

3-3
3.2.3 Disconnecting from Power
To disconnect the equipment from the AC power source, follow this procedure:
1. Confirm that the patient monitoring or therapy is completed.
2. Disconnect the patient cables and sensors from the patient.
3. Make sure to save or clear the patient data as required.
4. Turn the Mode Select Knob to Off. After 10 seconds, the equipment is shut down.
3.2.4 Auto Restoring to Last Configuration
During operation, you may make changes to some settings. However, these changes may not be saved as user
configuration. To prevent the changes from losing in case of sudden power failure, the equipment saves the settings in
real time. The saved settings are the latest configuration. In case of power failure, the equipment loads the latest
configuration if restarts within 60 seconds; it load the user configuration if restarts 120 seconds later after the power
failure; it may load either the latest configuration or the user configuration if restarts between 60 and 120 seconds after
the power failure.
3.3 Using the Main Menu
To enter the main menu, press the Main Menu button on the equipment’s front panel.
Other menus are similar to the main menu and contain the following parts:
1. Heading
2. Main body: displays options, buttons, prompt messages, etc. Pressing the menu button with “>>’’ enters a
submenu to reveal more options or information.
3. Exit button
3.4 Changing General Settings
3.4.1 Setting the Date and Time
1. Press the Main Menu button on the front panel, and then select [ Others >> ]
→
[ Configuration >> ] enter the
→
required password.
2. Select [ General Setup >> ].
3. Select [ Date Format ] from [yyyy-mm-dd ], [ mm-dd-yyyy ] and [ dd-mm-yyyy ].
4. Select [ Time Format ] and toggle between [ 24h ] and [ 12h ].
5. Set [ System Time ].
1
2
3