Mindray BeneHeart D3, Operator'S Manual

Page: 110 / 186

18-2
Automatic recordings will be triggered in the following conditions:
„
If both [ Alarm ] and [ Alm Rec ] for a measurement are switched on, an alarm recording will be triggered
automatically as an alarm occurs.
„
When related event is triggered.
To manually stop a recording, you can press the hardkey again.
Recordings stop automatically when:
„
A recording is completed.
„
The recorder runs out of paper.
„
The recorder has a failure.
„
Operating mode is changed.
NOTE
z
If you change the ECG Lead, Gain or Filter during recording, the recorded ECG waveform changes
accordingly, but the label of Lead, Gain or Filter recorded remains unchanged.
18.4 Setting the Recorder
18.4.1 Accessing the Record Setup Menu
To access the [ Record Setup ] menu, press the Main Menu button on the front panel and select [ Others>> ] [
→
Record
Setup >> ].
18.4.2 Selecting Waveforms for Recording
The recorder can record up to 3 waveforms at a time. You can select, in turn, [ Wave 1 ], [ Wave 2 ] and [ Wave 3 ] in the
[ Record Setup ] menu, and then select the waveforms you want to record. You can also turn off a waveform recording by
selecting [ Off ]. These settings are intended for realtime recordings.
18.4.3 Setting the Realtime Recording Length
After starting a realtime recording, the recording time depends on your equipment’s settings.
1. Enter the [ Record Setup ] menu.
2. Select [ Wave Length ] and toggle between [ 8 s ], [ 16 s ] and [ 32 s ].
‹
[ 8 s ]: record a waveform 4 seconds before and 4 seconds after the current moment;
‹
[ 16 s ]: record a waveform 8 seconds before and 8 seconds after the current moment;
‹
[ 32 s ]: record a waveform 16 seconds before and 16 seconds after the current moment;