Midas PRO6, Owner'S Manual

Page: 398 / 614

372
Appendix H: Updating The PRO6 Host Software
PRO6 Live Audio System
Owner’s Manual
6
A warning window will open (see below). To start the update procedure, click
Upgrade now.
After you start the installation, leave all of the system devices switched on
throughout the update procedure (see the
Caution at the start of this section).
During the update procedure the device blocks will change colour according to
their update status (see “Device blocks” on page 369). The green bar at the
bottom will show the progress of the current action, which is indicated by the text
immediately above. A typical screen display during the update procedure is
shown in Figure 39 “A typical updater display” on page 368.
7
When the update procedure has
finished, click Quit. The PRO6 and
all the units will return to normal
operating mode.
However, if any units have failed to
update (see “Device blocks” on
page 369), instead of clicking Quit
you can select them and start the
update procedure again.
The diagram right shows a typical
screen display of a successful
upgrade, where the device blocks
of all connected devices are green.
8
Power cycle the system to fully install the new software. Do this by powering the
system down and then powering it up again (see “Powering the PRO6 system” on
page 30).
>> To update your PRO6 Control System with a previous version of host
software
The procedure is just the same as if you are installing the latest version of host software
(as detailed above), but select the older file version you need from the
home
Preferences Upgrade submenu instead of the latest one.