Midas PRO6, Owner'S Manual

Page: 337 / 614

311
PRO6 Live Audio System
Owner’s Manual
Appendix A: Application Notes
This chapter provides more in-depth information on certain areas and functions of the
PRO6.
Spatial imaging system (SIS™)
Although conventional consoles can be used for three-channel mixing, the methods for
doing so are complicated and unorthodox. This forces the engineer to work in
unaccustomed ways, limiting creative flexibility, and making use by visiting operators
impractical. The spatial imaging system (SIS™) has been developed to overcome this.
The following are just some of the advantages provided by SIS™:
• Backing vocalists can be panned slightly towards the centre cluster to improve
intelligibility, while keeping the featured vocal ‘front and centre’.
• Musical instruments can be placed in a conventional mix then easily switched to the
centre for solos.
• In theatrical productions, SIS™ allows you to pan an actor’s voice across three
channels, following their on stage movements. In stereo-only productions the
centre output can be used to provide a mono-to-mix-base feed activating a single
‘left + right to centre’ switch.
• The ability of SIS™ to feed centre-panned signals equally to both left and right
outputs, as well as the centre, is particularly useful for distributing the load of high
energy, centre-panned sounds across all FOH loudspeaker arrays.
PRO6 compressor modes (dynamic)
This section aims to provide an understanding of the compressor modes contained
within the PRO6 Control Centre.
Description
The PRO6 compressors have five primary operating modes (only four on the inputs).
These change the signature (or shape) of the attack and release envelope curves,
interactions and timings. Before dealing with this in detail, some of the generic terms
are defined and explained:
Threshold
The threshold adjusts the operating point of the compressor. Signals that go over this
point, or over-threshold, will be affected by compressor action. Signals that stay below
threshold will not trigger any compression, although they may still be affected by
compression releases from previous over-threshold signals.
Ratio
The compression ratio control provides control of the amount of compression that is
applied to over-threshold signals. This is expressed as a ratio of signal level changes
from input to output. For example, when the compressor is set to 2:1, every 2dB input
level change will only generate a 1dB output level change (assuming the signal levels
are over-threshold).