Midas PRO6, Owner'S Manual

Page: 179 / 614

Flanger effect
153
PRO6 Live Audio System
Owner’s Manual
Flanger effect
The flanger effect consists of one or, if configured as stereo, two-tap delay lines. One
tap is fixed and the other tap position is modulated to provide ‘thru-zero’ flanging or
single tap modulation when ‘thru-zero’ is off.
1
Delay control knob for adjusting length of
modulated delay line in milliseconds. In ‘thru-
zero’ mode, also sets the delay of the dry path.
Range is 0.1 to 10, with 5 at top dead centre.
2
ON button is used to switch the flanger
effect on and off. Illuminates when power is
on.
3
Feedback control knob adjusts the
amount of negative/positive feedback applied
to the delay. Controls the number of repeats.
Range is from -100% to +100%, with 0% at
top dead centre.
4
37 yellow LED indicators for modulation
meter.
5
Out meters. Two rows of 15 green LEDs,
one each for L (left) and R (right).
6
In meters. Two rows of 15 green LEDs,
one each for L (left) and R (right).
7
Gain control knob for adjusting the signal
level in dB. Range is from -20dB to +20dB,
with 0dB at top dead centre.
8
Invert switch for inverting wet signal.
9
Mix control knob for adjusting the mix
between dry (0%) wet (100%).
10
Hi EQ control knob in the Filters section,
adjusts the amount of HF (high EQ) cut or
boost applied to the effect output in dB. Range
is -12dB to +12dB with 0dB at top dead centre.
11
Lo EQ control knob in the Filters section,
adjusts the amount of LF (low EQ) cut or boost
applied to the effects output in dB. Range is
-12dB to +12dB with 0dB at top dead centre.
12
HF Damping control knob, adjusts the
high frequency (kHz) tuning of flanger
feedback. Range is 1kHz to 20kHz, with 10kHz
at top dead centre.
13
LF Damping control knob, adjusts the
low frequency (kHz) tuning of flanger feedback.
Range is 20Hz to 1kHz, with 140Hz at top dead
centre.
14
Depth control knob in LFO Sweep panel,
controls the intensity of the effect by setting
the depth of modulation as a percentage.
Interactive with Delay, as for Chorus. Range is
0% to 100%.
15
Thru Zero switch in LFO Sweep panel,
selects ‘thru zero’ or normal mode. Illuminates
to indicate switch is on.
16
Spread control knob in LFO Sweep
panel, for setting relative phase of left/right
modulation. Range is 0 to 180, with 90 at top
dead centre.
17
Shape control knob in LFO Sweep panel,
adjusts shape of modulation waveform. Range
is from Tri to Exp.
18
Rate control knob in LFO Sweep panel,
adjusts rate of modulation (Hz). Range is
between 0.01 and 50, with 0.7 at top dead
centre.
3 1
2
4 5
6
7
8
9
10
11
12
13
15
16
17
18
14