Microscan Quadrus EZ, User Manual, Page: 79 / 366

Quadrus EZ Reader User’s Manual
3-25
Read Cycle
Dual Camera Switching
Note: The following options are only available when Active Camera is set to Dual.
Important Note: The Quadrus EZ does not control the timing of external cameras. Cap-
tures from external cameras are streamed into the Quadrus EZ. To be sure to receive a
complete first capture, allow up to 33mS delay before the first external capture.
Switching Mode
When Switching Mode is set to Number of Captures, the combined internal and external
camera captures can not exceed the total number set in Number of Captures; however if
the combined total is less than the total, then the capture pattern will be repeated until the
total number of captures has been met.
Switching by Number of Captures
Number of Internal Camera Captures
Usage: Useful where different symbols can appear within a single read cycle.
Definition:
When Active Camera is set to Dual, captures will alternate between the
internal and external cameras, starting with the internal camera.
Definition:
Captures can be set to alternate between the internal and external cameras
by the number of captures or by camera timeouts.
Serial Cmd:
< K243,switching mode ,number of internal captures,number of external
captures,internal camera timeout,external camera timeout>
Default: Number of Captures
Options:
0 = Number Of Captures
1 = Timeout
Definition:
The number of captures taken by the internal camera before switching to
the external camera.
Serial Cmd:
< K243, switching mode, number of internal captures ,number of external
captures,internal camera timeout,external camera timeout>
Default: 1
Options: 1 to 8