Microscan Quadrus EZ, User Manual, Page: 200 / 366

7-14
Quadrus EZ Reader User’s Manual
New Master Pin
New Master Pin
After New Master Pin has been enabled and the pin activated, decodes will be saved in
the master database beginning with master symbol #1. If the reader is configured for a
multisymbol read cycle (Number of Symbols is greater than 1), the remaining decodes
will be saved in each consecutive master symbol location. For example, if Number of
Symbols is set to 3 and New Master Pin is then activated, at the end of the next read
cycle, the decoded symbols will be saved as master symbols 1, 2, and 3.
Usage:
Some applications require the line worker to change the master symbol.
This can be done by installing a switch at the location of the reader. It is
very common to have a keyed switch so that accidental switching does not
occur.
Definition:
After New Master Pin is enabled, a pulse can be received on the new master
pin that will cause the reader to record the next decoded symbol(s) as the
new master symbol(s).
It is important to note that the enabling New Master Pin does not in itself
cause a master symbol to be recorded. The master pin must then be activated
momentarily (for a minimum of 10 ms) before a master symbol can be read
into memory.
Serial Cmd: < K225,status >
Default: Disabled
Options: 0 = Disabled 1 = Enabled