Microscan Quadrus EZ, User Manual, Page: 150 / 366

5-34
Quadrus EZ Reader User’s Manual
EZ Button
EZ Button
The EZ button has four positions, selectable by the length of time that the button is held
down and indicated by one, two, three, and four beeps in succession. Each position can
be programmed for any of eight options.
Disabled
When set to Disabled, the EZ button is disabled.
Enabled
When selected, the EZ Button is enabled and the function of each button position is
selected by the EZ Button Mode command.
Trigger Mode (EZ Button)
When selected, the EZ Button acts as a trigger for the reader to start and end read cycles.
All other button operations are inactive.
Default on Power-On (EZ Button)
Definition: Serves as a master switch to enable/disable the EZ button status.
Serial Cmd:
< K770,global status ,default on power-on,load IP database,save for
power-on>
Default: Enabled
Options: 0 = Disabled 1 = Enabled 2 = Trigger
In External
Level: The read cycle endures for as long as the EZ button is pressed, unless a
timeout occurs and Timeout is enabled for End Of Read Cycle.
In External
Edge:
As with Level, Edge allows a read cycle to be initiated by pressing the button,
but unlike level mode, the read cycle ends with a good read output, a timeout,
or a new trigger.
Definition:
When enabled, if the EZ button is held down on power-on the reader will
default to customer defaults and saved for power-on. This is the same as
sending a <
Zrc > command.
Serial Cmd:
< K770, global status, default on power-on ,load IP database,save for
power-on>
Default: Enabled
Options: 0 = Disabled 1 = Enabled