Microscan Quadrus EZ, User Manual, Page: 317 / 366

Quadrus EZ Reader User’s Manual
A-13
Appendices
Appendix F — Serial Configuration Commands
The following table is a summary of all the available serial configuration commands, pre-
sented in the order found in the chapters.
Serial Configuration Commands
Communications
Host Port Connections
< K100, baud rate,parity,stop bits,data bits>
Host Port Protocol < K140, protocol>
Host 232/422 Status < K102, host 422>
Auxiliary Port
< K101, aux port mode,baud rate,parity,stop bits,data
bits,daisy chain ID status,daisy chain ID>
Daisy Chain Autoconfigure < K150 DAISY>
Daisy Chain ID < K151, daisy chain reader #,daisy chain reader ID>
Ethernet Configuration
< K125, IP address,subnet address,gatewayaddress,IP
address mode,primary TCP port,video TCP port>
Preamble < K141, status,preamble characters>
Postamble < K142, status,postamble characters>
Response Timeout < K143, response timeout>
LRC < K145, status>
Aux Port System Data Status < K146, aux port system data>
Read Cycle
Multisymbol
< K222, number of symbols,multisymbol separator>
Trigger Mode/Duration < K200, trigger mode,trigger filter duration>
External Trigger State < K202, extermal trigger state>
Serial Trigger Character < K201, serial trigger character>
Start Trigger Character < K229, start character>
Stop Trigger Character < K230, stop character>
End of Read Cycle < K220, end of read cycle,read cycle timeout>
Active Camera < K240, active camera>
Captures
< K241, capture mode,number of captures,rapid capture
mode>
Capture Timing
< K242, time before 1st capture,time between capture 1 and
2,,,,,,,,time between capture 7 and 8>
Dual Camera Operations
< K243, switching mode,number of internal camera captures,
number of external camera captures,internal camera timeout,
external camera timeout>
Store Noread Image
< K244, image storage type,image storage mode>