Microscan Quadrus EZ, User Manual, Page: 254 / 366

12-2
Quadrus EZ Reader User’s Manual
Utilities Serial Commands
Utilities Serial Commands
Read Rate
<C> Enter Decode Rate Test
<Cp> Enter Percent Rate Test
<J> Exit Decode Rate and Percent Rate Test
Counter Request
and Clear
<N> Noread Counter
<O> Noread Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
<V> Good Read/Match Counter
<W> Good Read/Match Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
Master Database
<E> Enable Master Symbol
<F> Disable Master Symbol
<G> Store next Symbol read to Database.
<M?> Request Master Symbol Information
<K231,master symbol
number,master symbol
data>
Request Master Symbol Information for specific database
number.
Part Number
Checksum/
<#> Display Software Code Part Numbers
<#a> Display Application Code Part Number
<#b> Display Boot Code Part Number
<#d> Display DSP Part Number
<#f> Display FPGA Part Number
<!> Display all 3 Checksums of Flash memory
<!a> Display Application Code Checksum
<!b> Display Boot Code Checksum
<!d> Display DSP Code Checksum
<!f> Display FPGA Code Checksum
Device Control
<L1> Programmable Output 1
<L2> Programmable Output 2
<L3> Programmable Output 3
Default/Reset/Save
<A> Reset (does not save for power-on)
<Ard> Reset and recall Microscan defaults
<Arp> Reset and recall power-on parameters
<Arc> Reset and recall customer default parameters
<Z> Save current settings for power-on
<Zc> Save current settings as customer default parameters
<Zrd> Recall Microscan default parameters and save for power-on
<Zrc> Recall customer default parameters and save for power-on
Reader Status
Commands
<K?> All Configuration Commands Status
<-> Input Status
<?> Reader Status
<?1> Extended Reader Status