57
10. Remove the pump driveshaft from the drive hub in
the rear wall of the mix hopper. (See Figure-103.)
Figure-103
Remove the two small O-rings and one large
O-ring from the pump driveshaft.
Disassembly—Soft Serve Side
Note:
Failure to remove the parts specified below for
brush-cleaning and lubrication will damage the machine.
These parts must be removed every 14 days or the
machine will lock out and will not operate.
1. Make sure the power switch is in the OFF position.
2. Remove the handscrews, freezer door, beater,
scraper blades, and driveshaft with driveshaft seal
from the freezing cylinder.
3. Remove the driveshaft seal from the driveshaft.
4. From the soft serve pump cylinder, remove the
retaining pin, mix inlet adaptor, valve cap, pump
gasket, and piston. Remove the O-ring from the
piston and valve cap.
5. Remove the freezer door gasket, front bearing, pivot
pin, draw handle, and draw valve. Remove the three
O-rings from the draw valve.
Note: Do not
attempt to remove the star design from the
door.
The star design is part of the door and is
not
a
removable piece. (See Figure 104.)
Figure-104
Note:
Remove the pump driveshaft from the drive hub in
the rear wall of the mix hopper. (See Figure-105.)
Figure-105
Remove the two small O-rings and one large
O-ring from the pump driveshaft.
6. Remove the front drip tray and splash shield.
Remove the ladles from the two cold topping
containers.
7. Remove the long drip pan from the front panel. Take
it to the sink for cleaning. (See Figure-106.)
Figure-106
Summary of Contents for C602
