41
Syrup Priming Procedure
Priming the syrup line eliminates any air in the syrup
delivery system. Air in the syrup line can cause irregular
shake blending, flavor carryover, and syrup leaking from
the door spout after the draw valve has closed. Each time
a syrup container is drained or replaced, prime the syrup
system until all the air has been removed and the syrup
flow is uniform.
1. Retrieve a full syrup container from the dry storage
area.
2. Shake the syrup container prior to opening it. Open
the full syrup container.
3. Pull the feed tube from the empty syrup container
and clean the outside of the feed tube with a clean,
sanitized towel.
For syrup bag system:
Disconnect the empty bag and
clean the hose connector fitting with a clean, sanitized
towel. Attach the hose connector fitting to a full bag of
syrup. Place the bag on the shelf in the syrup
compartment. Make sure the hose is not pinched and
there are no kinks in the tubing.
4. Place the feed tube into the full syrup container and
replace the syrup container in the syrup cabinet.
5. Dispose of the empty syrup container.
6. Prime the syrup line by removing the syrup valve
from the freezer. Hold it over an empty cup.
7. Press the Calibrate symbol
to display the menu
options. The Calibrate symbol
, the Auto symbol
on the shake side, and the optional Flavor symbol
will be illuminated.
The screen will display the Calibration Menu options.
(See Figure-48.)
Figure-48
8. Press the Auto symbol
or the optional Flavor
symbol
to scroll the arrow to SYRUP PRIME.
Figure-49
9. Press the Calibrate symbol
to enter the Syrup
Prime mode. (See Figure-50.)
Figure-50
10. Press the corresponding syrup Flavor symbol
.
The Flavor symbol should be illuminated and the
syrup pump for the selected flavor will start running at
the maximum speed. (See Figure-51.)
Figure-51
11. When a steady stream of syrup is flowing from the
syrup valve and all air has been purged from the
syrup line, press any syrup Flavor symbol
to stop
the pump.
12.
Repeat steps 10 and 11
for any other syrup lines to
be primed, or exit the Syrup Prime mode by pressing
the Calibrate symbol
.
Summary of Contents for C602
