McDonald's C602, Manual

Page: 46 / 114

44
16. Fill the squeeze bottle with sanitizing solution. Hold
the bottle over a pail. Squeeze the bottle and
thoroughly rinse the slot of each syrup nose fitting.
(See Figure-60.)
Figure-60
17. Wipe the outside of each syrup nose fitting with a
sanitized towel.
18. Using a clean, sanitized towel, wipe down the freezer
door, front panel, the area around the bottom of the
freezer door, and any other areas that show a buildup
of either moisture or food substance.
19. Use a clean, damp, sanitized towel to gently wipe the
portion control sensor shield and remove any mix
buildup. Inspect the sensor shield for damage and
replace if necessary. (See Figure-61.)
Figure-61
Soft Serve Side
Note: This procedure must be done at the close of
business.
Important! Fill the mix hopper with mix up to the fill level
indicator on the agitator paddle. (See Figure-62.)
Figure-62
Both sides of the freezer must be in the Auto mode (Auto
symbol is illuminated) or in the Standby mode
(Standby symbols and are illuminated) before the
Heat cycle can be started.
Note: If the Brush-Clean Counter display has counted
down to 1 day, do not add mix. The machine must be
disassembled and brush-cleaned within 24 hours.
1. Place the topping heaters in the OFF position by
pressing the Heater symbols . The symbols
will not be illuminated when the heaters are off.

(See Figure-63.)
Figure-63
2. Remove the hopper cover.