McDonald's C602, Manual

Page: 75 / 114

73
12. Remove the cotter pin from the pump. Stand the mix
feed tube in the corner of the mix hopper. Place the
cotter pin in position in the outlet fitting of the pump.
(See Figure-166.)
Figure-166
Note: You have just sanitized all the food contact
surfaces of the freezer.
Priming—Shake Side
Note: Use only fresh mix when priming the freezer.
1. With a pail beneath the door spout, press any Flavor
Selection symbol to open the draw valve. Pour

2-1/2 gal. (9.5 L) of fresh mix into the mix hopper and
allow it to flow into the freezing cylinder. This will
force out any remaining sanitizing solution. When

full-strength mix is flowing from the door spout, press
any Flavor Selection symbol to close the draw
valve.
Important! Failure to remove all sanitizing solution may
damage the freezing cylinder.
2. When the mix stops bubbling down into the freezing
cylinder, remove the cotter pin from the outlet fitting
of the mix pump. Insert the outlet end of the mix feed
tube into the mix inlet hole in the mix hopper. Place
the inlet end of the mix feed tube into the outlet fitting
of the mix pump. Secure with cotter pin.

(See Figure-167.)
Figure-167
3. Install the shake cup holder. (See Figure-168.)
Figure-168
4. Select the Auto symbol .
5. Fill the hopper with fresh mix and place the mix
hopper cover in position.
Priming—Soft Serve Side
Note: Use only fresh mix when priming the freezer.
1. With a pail beneath the door spout, open the draw
valve. Pour 2-1/2 gal. (9.5 L) of fresh mix into the mix
hopper and allow it to flow into the freezing cylinder.
This will force out any remaining sanitizing solution.
When full-strength mix is flowing from the door spout,
close the draw valve.
Important! Failure to remove all sanitizing solution may
damage the freezing cylinder.