94
Excessive mix
leakage from the
bottom of door spout.
a. Bottom O-ring on the
draw valve is
improperly lubricated or
worn.
a. Lubricate properly or replace the O-ring.
Excessive mix
leakage into the long
drip pan.
a. The seal on the
driveshaft is improperly
lubricated or worn.
b. Lubricate properly or replace the seal.
b. The seal is installed
inside-out on the
driveshaft.
c. Install correctly.
c. Inadequate lubrication
of the driveshaft.
d. Lubricate properly.
d. The driveshaft and
beater assembly work
forward.
e. Call a service technician.
e. Worn rear shell
bearing.
f. Call a service technician.
f. Gearbox out of
alignment.
g. Call a service technician.
The driveshaft is stuck
in the drive coupling.
a. Mix and lubricant
collected in drive
coupling.
a. Brush-clean the rear shell bearing area regularly.
b. Rounded corners of
the driveshaft, drive
coupling, or both.
b. Call a service technician.
c. Gearbox is out of
alignment.
c. Call a service technician.
Problem
Shake Side
Probable Cause
Soft Serve Side
Probable Cause.
Either Side Probable
Cause
Corrective Action
Summary of Contents for C602
