58
8. Remove the two short drip pans from the rear panel.
Remove the two notched drip pans from the left and
right side panels. Take them to the sink for cleaning.
(See Figure-107.)
Figure-107
Note:
If the drip pans are filled with an excessive amount
of mix, it is an indication that the driveshaft seal(s) or
O-ring(s) should be replaced or properly lubricated.
Brush-Cleaning
We recommend brush-cleaning all the shake parts, then
going back and duplicating these steps (where they
apply) for brush-cleaning all the soft serve parts. By
doing so, you will not confuse or interchange these parts
for assembly the next morning. Place the parts in their
proper place in the parts tray.
1. From the sink proportioner, draw SolidSense™ All
Purpose Super Concentrate (APSC) (HCS) solution
into a sink.
Make sure all brushes provided with the freezer are
available for brush-cleaning.
2. Thoroughly brush-clean all disassembled parts and
parts trays in the cleaning solution, making sure all
lubricant and mix film is removed. Make sure to brush
all surfaces and holes, especially the holes in the
pump components and the small syrup holes in the
shake freezer door.
3. Rinse all parts with clean, warm water, one tray at a
time, including the tray.
4. Return to the freezer with a small amount of cleaning
solution. Using the black brush, clean the rear shell
bearings at the back of the freezing cylinders.
Figure-108
5. Using the black brush, clean the drive hub openings
in the rear wall of the mix hoppers. (See Figure-109.)
Figure-109
6. Using the double-end brush, brush-clean the syrup
line fittings.
7. Prepare a sink with KAY-5
®
Sanitizer (HCS) solution.
Use one packet in 2.5 gal. (9.5 L) of water (100 ppm).
8.
Repeat step 3
with the sanitizing solution.
9. Sanitize all parts in the KAY-5
®
Sanitizer (HCS)
solution for a minimum of 1 minute.
10. Place disassembled parts on clean and sanitized
parts trays.
11. Wipe all exterior surfaces of the freezer with a clean,
sanitized towel.
12.
Repeat steps 1 through 10
for the soft serve side of
the freezer.
Summary of Contents for C602
