49
30. Clean the syrup cabinet interior with a clean,
sanitized towel. Spray resistant areas with
KAY-5
®
Sanitizer (HCS).
SYRUP TOPPING PUMP
Syrup Topping Pump Disassembly
Before the first use and after use weekly, disassemble
and clean the pump.
1. Flush and rinse the pump in a container of warm
water. Place the lower end of the pump into the water
container. Operate the pump until only warm water
flows from the discharge tube.
2. Remove the pump from the container of water for
disassembly.
3. Remove the plunger assembly from the pump body
by turning the plunger nut counterclockwise.
Figure-72
4. To remove the knob, compress the spring by holding
the nut and pressing on the end of the plunger. Turn
the knob counterclockwise. (See Figure-73.)
Figure-73
5. Remove the plunger nut, tube, and insert from the
plunger assembly. (See Figure-74.)
Figure-74
6. Remove the spring and washer from the plunger
assembly. (See Figure-75.)
Figure-75
7. Remove the seal assembly from the plunger
assembly. (See Figure-76.)
Figure-76
Summary of Contents for C602
