MacDon A40-D, Operator'S Manual

Page: 64 / 240

214804
50
Revision A
Figure 3.60: Draper Header Hose Position (M150
Shown; M200, M155, and M155
E4 Similar)
1. Move left windrower platform to open position to expose
hydraulic valve blocks.
2. Disconnect jumper hose (B) from 90 degree fitting (C)
at port R4 on the reverser valve block (A).
3. Rotate 90 degree fitting (D) under reverser valve block
so hose can be routed to port C2 at (C) as shown in
Figure
3.61, page 50 .
Figure 3.61: Connected Jumper Hose
4. Remove cap from port C2 fitting (A) on the header drive
valve block (B).
5. Connect jumper hose (C) to port C2 fitting (A) on
header drive valve block (B).
6. Install previously removed cap onto 90 degree fitting in
port R4 on reverser valve block (D).
7. Move left windrower platform back to normal operating
position.
NOTE:
The draper header reverser function is suppressed
unless hay conditioner is activated in Windrower Setup
using the cab display module (CDM).
3.3.6 Routing A40D Hydraulic Drive Hoses
The A40D Auger Header hydraulic drive hose routing depends on the windrower model to which the header is
being attached.
A40D Headers are factory-configured for M150, M155, M155 E4 , and M200 SP Windrowers as shown in
Figure 3.66, page 52 .
To route hoses for M100, M105, and M205 SP Windrowers, proceed as follows:
OPERATION