MacDon A40-D, Operator'S Manual

Page: 67 / 240

214804
53
Revision A
e. Confirm orientation of upper port 45 degree fitting,
back-off tee (B), and tighten upper port fitting in
position determined. Tighten hose (A).
f. Check orientation of lower port 45 degree fitting
and tighten.
g. Connect tee (B) to lower port 45 degree fitting and
tighten.
Electrical harness routing:
Figure 3.68: Adjusted Configuration (M100,
M105, and M205)
7. Secure electrical harness (B), motor case drain
hose (C), and hose (D) together with cable ties (A),
as shown.
IMPORTANT:
Ensure there is at least 25 mm (1 in.) clearance
between hose bundle (E) and knife drive timing belt (F).
Figure 3.69: Auger and Reel Pressure Coupler
and Hose
–
4.3 m and 4.9 m (14 ft. and 16 ft.)
Header Shown
8. Rotate coupler (B) and hose (C) downward as shown
until slack has been sufficiently reduced. Tighten
bulkhead nut (A).
OPERATION