MacDon A40-D, Operator'S Manual

Page: 167 / 240

214804
153
Revision A
Figure 4.94: Cover
17. Reposition cover (A) on cam, and tighten bolt.
4.9.2 Replacing Tine and Bearing: Disc #2
Figure 4.95: Cam End Disc
Replace tine and bearing at disc #2 (A) as follows:
IMPORTANT:
Tine attachment hardware and configuration may vary
between Tine Bar Type A and Tine Bar Type B. Identify
locations so that tine hardware will be reinstalled at same
locations. Both Tine Bar Type A and Tine Bar Type B
configurations are required to stagger tines on the reel bat
and ensure all crop is picked up.
Type A tine bars
Figure 4.96: Tine Bar Type A
1. Remove flangette mounting bolts (A) at reel disc #2.
2. Remove shoulder bolts (B) and keeper (C) from
tine bar.
3. Separate left tine bar (D) with bearing from center tine
bar (E).
4. Remove tine from center tine bar (E).
MAINTENANCE AND SERVICING