MacDon A40-D, Operator'S Manual

Page: 116 / 240

214804
102
Revision A
4.3 Endshields
This procedure is for opening and closing the endshields at each end of the machine.
To open endshields:
CAUTION
Ensure shield lock engages in the open position as shown at (B) before letting go of shield.
Figure 4.4: Screwdriver against Latch
1. Insert screwdriver or equivalent into opening (A) at base
of endshield and push to release latch.
2. Pull bottom and lift endshield until shield support (B)
engages bolt. Check that support (B) is engaged before
releasing hold on shield.
To close endshields:
3. Grasp endshield at top and push slightly and move support (B) inboard to disengage.
4. Lower endshield to about 300 mm (12 in.) from closed position.
5. Release endshield so that it drops to closed position and shield will self-latch.
MAINTENANCE AND SERVICING