MacDon A40-D, Operator'S Manual

Page: 190 / 240

214804
176
Revision A
Figure 4.146: Forming Shield Attached to
Windrower Frame
6. Lift aft end of the forming shield and attach straps (B) to
pins (A) on the windrower frame. Install washer and
hairpin to secure strap. Use the middle hole and adjust
height to suit the crop.
Figure 4.147: Side Deflectors and Fluffer Shield
7. Set forming shield side deflectors to desired width by
positioning adjuster bars (A). Use the same hole
location on both sides.
•
Position deflectors at the narrowest setting for a
narrow windrow (silage for example).
•
Position deflectors at the widest setting for a wide
windrow.
Refer to 3.6.14 Positioning the Forming Shields, page
79 .
8. Adjust fluffer shield (C) to middle position. Loosen
handles (B) if required. Refer to
Positioning Rear
Deflector (Fluffer Shield), page 80 .
4.13.6 Removing Header Drive Motor
This procedure applies to A40D and A40DX (excluding Grass Seed A40D and Grass Seed A40DX) double-knife
headers.
CAUTION
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1. Shut down the engine, and remove key from ignition.
2. Open conditioner driveshield.
IMPORTANT:
Mark hoses and make a diagram of hose routing. This is useful during reassembly.
3. Disconnect hoses at couplers on motor.
MAINTENANCE AND SERVICING