MacDon A40-D, Operator'S Manual

Page: 81 / 240

214804
67
Revision A
Figure 3.93: Auger Header Left Side
6. Tighten nuts (A).
Figure 3.94: Auger Header Right Side
7. Open right endshield.
8. Loosen four nuts (A).
Figure 3.95: Auger Header Left Side
9. Loosen jam nuts on adjuster bolts (A), and turn bolts (A)
to adjust reel vertical position.
NOTE:
The factory setting at forward adjuster bolt should be
12 mm (15/32 in.) lower than at rear adjuster bolt. If tine
aggressiveness has changed, then the adjuster bolt
offset may not equal factory settings. Always measure
the adjuster bolt offset and maintain throughout the
vertical adjustment.
10. Tighten jam nut.
OPERATION