MacDon A40-D, Operator'S Manual

Page: 195 / 240

214804
181
Revision A
Figure 4.159: Header Drive
9. Install knife drive V-belts (A). Refer to Installing Double
V-Belts, page 141 .
Figure 4.160: Gearbox
10. Remove oil level check plug (A) in gearbox. If oil does
not run out, add oil to required level. If oil is required,
refer to the chart on the inside back cover of this
manual.
Figure 4.161: Upper and Lower Drivelines
11. Align keyway in upper driveline yoke (B) with key in
gearbox shaft and attach yoke (B) to shaft.
12. Install two hex head bolts (A) and flanged lock nuts to
secure yoke. Tighten bolts.
13. Install timing flange on lower driveline (D) onto lower
shaft on gearbox with four hex head bolts (C), two flat
washers (E) under each bolt head, lock washers (F)
and plain nuts (G). Do
NOT tighten.
MAINTENANCE AND SERVICING