MacDon A40-D, Operator'S Manual

Page: 63 / 240

214804
49
Revision A
Figure 3.58: Modified Routing M100, M105,
and M205
15. For procedure to change hose routing for M205
Windrowers, refer to 3.3.6 Routing A40D Hydraulic
Drive Hoses, page 50 .
3.3.5 Configuring Reverser Valve Jumper Hose for A40D
Figure 3.59: A40D Hose (B) Position (A40D on
M200 Shown; M150, M155, and M155
E4 Similar)
An optional reverser valve block (A) to reverse the header
drive in the event of plugging may have been installed on
M150, M155, and M200 Self-Propelled Windrowers. A
jumper hose on this valve block has a specific routing for
each model of header.
NOTE:
If a reverser valve block (A) has been installed, the jumper
hose (B) must be routed for the correct header model. Do
NOT operate the header unless hose is routed as shown.
NOTE:
ONLY for draper headers with conditioner installed and
ONLY for the M150, M155, and M200 windrowers: CR is
routed to port R4 (not shown) on reverser block. When
switching from draper header to auger header, jumper
hose (B) must be routed according to the header being
operated to prevent draper header reel damage and
improper operation.
To reroute jumper hose from draper header position to
A40D position, follow these steps:
OPERATION