MacDon A40-D, Operator'S Manual

Page: 105 / 240

214804
91
Revision A
Figure 3.126: Left Side Deflector and Hardware
3. Install left side deflector (A) using nuts and bolts (B) and
nut, bolt, and five washers (C) retained from the
previous step. Torque all nuts to 11.5 Nm (102 lbf·in).
NOTE:
Do NOT install nut (D) if the pan extension
’
s width will
be adjusted.
NOTE:
Do NOT torque nuts if the pan extension
’
s width will be
adjusted.
4. Repeat steps for installing the pan extension on the
opposite side of the header.
To adjust a pan extension
’
s width, do the following:
Figure 3.127: Left Side Pan Extension
1. Remove nut and bolt (A).
2. Loosen nut (B), but do NOT remove.
3. Slide pan extension (C) with swath forming rods inboard
to the desired position, aligning holes on the pan
extension and header.
Figure 3.128: Left Side Pan Extension
4. Replace bolt and nut (A). Torque nut (A) and nut (B) to
11.5 Nm (102 lbf·in).
5. Install nut and bolt (C) and torque to 11.5 Nm
(102 lbf·in).
6. Repeat for adjusting the pan extension on the right side
of the header.
OPERATION