MacDon A40-D, Operator'S Manual

Page: 43 / 240

214804
29
Revision A
3.2 Detaching A40DX Header from M1 Series Windrower
Refer to your windrower operator
’
s manual for procedures to mechanically detach the auger header from the
M1 Series Windrower. To detach an A40DX header
’
s hydraulics and electrical from an M1 Series Windrower, follow
these steps:
CAUTION
To prevent accidental movement of windrower, return ground speed lever (GSL) to Park, center steering
wheel to lock, shut off engine, and remove key.
Figure 3.8: Windrower Electrical Connector
1. Disconnect header electrical harness from
receptacle (A) on windrower multicoupler.
NOTE:
Upper harness connection also needs to be
disconnected if reel speed kit option is connected.
Figure 3.9: Multicouplers
2. Push button (E) on front multicoupler, and pull
handle (F) away from windrower.
3. Remove multicoupler (G) from receptacle and set
aside. Clean multicouplers and receptacles to prevent
contamination. Install caps and plugs on hoses and
fittings (if equipped).
4. Close cover (H) and push handle (F) towards windrower
until button (E) snaps out.
5. Push button (A) on rear multicoupler, and pull
handle (B) away from the windrower.
6. Remove multicoupler (D) from receptacle and set aside.
Clean multicouplers and receptacles to prevent
contamination. Install caps and plugs on hoses and
fittings (if equipped).
7. Close cover (C) and push handle (B) towards
windrower until button (A) snaps out.
OPERATION