MacDon A40-D, Operator'S Manual

Page: 168 / 240

214804
154
Revision A
Figure 4.97: Tine Bar Type A
5. Remove bearing (A) from tine bar connecting shaft (B).
Refer to
4.5.4 Installing Sealed Bearings, page 115 .
6. Remove nuts (C), shoulder bolts (D), keepers (E) from
left tine bar (F) and remove tines (G).
Figure 4.98: Tine Installation
7. Replace tines as follows:
a. Remove bolt (A) and keeper (B) on tine to be
replaced.
b. Remove bolts and keepers on tines as required to
facilitate replacement of damaged or worn tine.
c. Slide tines off tine bar.
d. Install replacement tine on tine bar and secure with
bolt (A) and keeper (B). Install nut with flat side
against tine bar.
e. Slide remaining tines onto tine bar and attach to
tine bar. Do
NOT install bolts in end tines at
this time.
Figure 4.99: Tine Bar Type A
8. Install end tines (G) onto left tine bar (F) with shoulder
bolts (D), keepers (E), and nuts (C).
9. Assemble new bearing (A) with flangettes onto
connecting shaft (B). Refer to
4.5.4 Installing Sealed
Bearings, page 115 .
MAINTENANCE AND SERVICING