MacDon A40-D, Operator'S Manual

Page: 94 / 240

214804
80
Revision A
Figure 3.116: Forming Shield Side Deflector
1. Set forming shield side deflectors to desired width by
repositioning adjuster bars as follows:
a. Remove lynch pin (A).
b. Move adjuster bar (B) to another hole.
c. Reinstall lynch pin (A).
Figure 3.117: Forming Shield Adjustment Nut
2. If forming shield attachment is too tight or too loose,
tighten or loosen nut (A) as required.
Positioning Rear Deflector (Fluffer Shield)
The rear deflector (A) slows the crop exiting the conditioner rolls, directs the flow downward, and fluffs the material.
CAUTION
To prevent accidental movement of windrower, return ground speed lever (GSL) to Park, center steering
wheel to lock, shut off engine, and remove key.
OPERATION