MacDon A40-D, Operator'S Manual

Page: 163 / 240

214804
149
Revision A
4.9 Reel Tines and Tine Bar Bearings
Separate procedures are required to replace reel tines, depending on their location on the reel. Refer to the
following topics for these procedures:
•
4.9.1 Replacing Tine and Bearing: Cam End
–
Disc #1, page 149
•
4.9.2 Replacing Tine and Bearing: Disc #2, page 153
•
4.9.3 Replacing Tine and Bearing: Center Section X, page 157
•
4.9.4 Replacing Tine and Bearing: Opposite Cam
–
Section Y, page 159
•
4.9.5 Replacing Tine: Tine Bar Extension
–
Section Z, page 161
IMPORTANT:
Keep reel tines in good condition. Straighten or replace as required.
4.9.1 Replacing Tine and Bearing: Cam End
–
Disc #1
NOTE:
Apply a light coating of anti-seize compound to tine tube connections and all bolts prior to reassembly.
Figure 4.83: Cam End Disc
Replace tines and bearing at disc #1 (A) as follows:
Figure 4.84: Cam Disc
1. Loosen bolt on cover (A), and slide cover to expose
hole in cam disc. Rotate reel, and align bearing
with hole.
MAINTENANCE AND SERVICING