MacDon A40-D, Operator'S Manual

Page: 166 / 240

214804
152
Revision A
Figure 4.91: Type A Tine Bar
IMPORTANT:
Replace hardware at cam end of tine bar with hardware
as specified in the following steps.
13. Position tines as shown and install bolts (A) with
keepers, spacers (B), and nuts (C).
14. Install bolts (D), spacers (B), and nuts (C) between
tines as shown.
15. Alternate hardware configuration to include both Type A
Tine Bar and Type B Tine Bar configurations:
a. 5/16 x 2 1/2 in. carriage bolt (A)
b. Spacer (B)
c. Lock nut (C)
d. 5/16 x 2 in. hex head bolt (D)
Figure 4.92: Type B Tine Bar
A - Carriage Bolts B - Spacers
C - Lock Nuts D - Hex Head Bolt
Figure 4.93: Cam Arm Bearing
16. Install cam follower bearing (A) with bolt (B). Apply
medium-strength threadlocker (Loctite
®
262 or
equivalent) to bolt threads, and torque to 122 Nm
(90 lbf·ft).
IMPORTANT:
Install nut with distorted thread TOWARDS bolt head.
MAINTENANCE AND SERVICING