MacDon A40-D, Operator'S Manual

Page: 172 / 240

214804
158
Revision A
Figure 4.109: Disc #3
5. Remove tine as follows:
a. Remove bolt (A) and keeper (B) on tine to be
replaced.
b. Remove bolts and keepers on tines as required to
facilitate replacement of damaged or worn tine.
c. Slide tines off tine bar.
d. Install tines on tine bar, and secure with bolts (A)
and keepers (B). Install nut with tapered side
against tine bar. Do
NOT install bolts in end tines at
this time.
Figure 4.110: Disc #3
A - Flangette Mounting Bolts B - Shoulder Bolts
C - Keeper X - Section X
Y - Section Y
6. Assemble tine bar section Y (including reel bearings at
discs #3 and #4) to tine bar section X at reel disc #3.
7. Position tines as shown, and install shoulder bolts (B)
with keeper (C).
Figure 4.111: Disc #4
8. Attach bearing flangettes to reel arm at discs #3 and #4
with bolts (A). Tighten bolts to 31
–
36 Nm (23
–
26 lbf·ft).
MAINTENANCE AND SERVICING