MacDon A40-D, Operator'S Manual

Page: 89 / 240

214804
75
Revision A
Figure 3.110: HPT Display
–
Adjusting Float
3. Press soft key 3 (A) to remove or restore the
header float.
NOTE:
If the header float is active, the icon at soft key 3 will say
REMOVE FLOAT; if header float has been removed, the
icon will say RESTORE FLOAT.
3.6.11 Setting Feed Pan and Rock Drop Tine Position
The rear of the feed pan is adjustable up and down to raise or lower the feed pan and rock drop tines.
•
Lowering the feed-pan helps prevent plugging in heavy crop.
•
Raising the feed-pan helps to form an even windrow in light crop.
WARNING
To avoid bodily injury or death from fall of raised machine, always lock-out lift cylinders before going
under header for any reason.
1. Raise header fully, and engage safety props.
2. Stop engine and remove key.
Figure 3.111: Rock Drop Tine Support
3. Loosen nut (A) both sides, and align pointer (B) at each
side of rock drop tine support with one of the slots (C) to
match crop condition.
Crop Condition Light Normal Heavy
Slot Upper Center Lower
OPERATION