MacDon A40-D, Operator'S Manual

Page: 88 / 240

214804
74
Revision A
Figure 3.107: HPT Run Screen
3. Press rotary scroll knob (A) on the HPT to display the
QuickMenu system.
4. Rotate scroll knob (A) to highlight header float icon (B)
and press scroll knob to select.
Figure 3.108: HPT Left/Right Float Settings
5. Turn scroll knob (A) to highlight left (B) or right (C) float
and press knob (A) to activate selection.
6. Rotate scroll knob (A) to adjust float setting and press
knob when finished. Float is now set.
NOTE:
Float adjustments of 1.0 (out of 10) change the header
weight at the cutterbar by approximately 91 kg (200 lb.).
Adjust float in increments of
0.05 to optimize field
performance.
7. Use soft key 3 (D) to remove/resume float and deck
position to previous setting for the attached header.
Removing and Restoring Float
Follow these steps to remove and restore the header float settings:
Figure 3.109: HPT Run Screen
1. Press rotary scroll knob (A) on Harvest Performance
Tracker (HPT) to display the QuickMenu system or
press F1 on the console.
2. Rotate scroll knob (A) to highlight header float icon (B)
and press scroll knob to select.
OPERATION