MacDon A40-D, Operator'S Manual

Page: 55 / 240

214804
41
Revision A
Figure 3.37: Auger Header Drive and Draper
Header Reel Drive and Lift Plumbing Kit
(MD #B4651)
If only three drive hoses are present, before following the
procedure below, configure the M200 to run an A40D Auger
Header by installing kit MD #B4651. The kit includes an
additional hose (A), hardware, and installation instructions.
Figure 3.38: Driveline Shield
1. Disengage rubber latch (A), and open driveline
shield (B).
Figure 3.39: Support Bracket and Hose Bundle
2. Remove cap (A) from electrical connector, and remove
connector from support bracket.
3. Disengage and rotate lever (B) counterclockwise to fully
up position to release the hose bundle (C).
OPERATION